AGS 3500

AGS 3500 is a water-carried all-weather long-term graffiti protection, formulated for most types of surfaces.

Download safety sheet

Download product sheet

SKU: 3500 Categories: ,


AGS 3500 is a water-carried all-weather long-term protection, formulated for most types of surfaces. Provides strong protection against spray paint, marker/felt-tip pens and mechanical damage. Protects against airborne pollution and moisture for a minimum of 5 years. Permeable and allows protected surface to breathe. Correctly applied, life expectancy against graffiti is approximately 5 years. Prevents graffiti from penetrating into substrate. A so called sacrificial coating, which means that surface must be re-protected, following graffiti removal. AGS 3500 is biodegradable.

Application instructions

Clean off both graffiti and other contamination, such as traffic dirt, wax, oil and paint-residue etc. from substrate. Mask and protect windows in a suitable manner. Ideal temperature for external application should be between 10-35°C. Minimum temperature is +5°C. Relative humidity must not exceed 95%..
Note! Fresh concrete has to cure for at least 28 days before protection.

Exterior protection
Shake or stir product well prior to use. AGS 3500 can be applied with a low-pressure sprayer or airless spray gun. The protection is applied 2-3 times. Note! Allow some drying between applications. AGS 3500 can be applied to a damp, but not wet surface. Runs and/or excessive application can easily be washed off with water, following completion of work.

Exterior graffiti removal
Method 1 – Normal substrate
Remove graffiti with hot water and high-pressure (90°C & 90-150 bar/ 1300-2175 PSI). In difficult cases AGS graffiti removers are used in conventional manner. Re-protect cleaned area.

Method 2 – Sensitive substrate
Apply AGS 3505 with a low-pressure sprayer. Allow a few minutes for the solvent remover to act and then rinse off with hot water (60-90°C & 60-80 bar/870-1160 PSI). The method is most suitable when substrate is brittle. Any graffiti left on the surface can be removed with AGS 3505 on a cloth. The cleaned area should be neutralised with water. Re-protect cleaned area.

Re-protection of cleaned surface
When removing graffiti, the protective coating is also normally removed. Re-protect 2-3 times with AGS 3500.

Use in concentrated form.

Varies depending upon type of surface material. Its porosity and capillary ability etc.


  • Concrete, brick or similar, a total for 3 layers will be 0,25-0,3 ltr/m².
  • Sandstone, plaster or other soft absorbent surfaces, a total for 3-4 layers will be 0,3-0,4 ltr/m².

The protected surface will be water- and graffiti-resistant after 2 hours and dry after 4 hours. Ultimate protective effect will be achieved after 72 hours.

Store frost-free in closed original container.

Shelf life
Approximately 12 months in unopened container.

Use protective clothing and gloves.

Additional information


1000 liter, 200 liter, 25 liter, 5 liter


, , , ,


Brick, Concrete, Granite – untreated, Limestone, Marble – untreated, Mineral and stone surfaces, Terrazzo, Wood – painted, Wood – untreated